DC Motors

A DC motor works by converting electric power into mechanical work. This is accomplished by forcing current through a coil and producing a magnetic field that spins the motor. The simplest DC motor is a single coil apparatus, used here to discuss the DC motor theory. The process can be explained in further detail by observing the diagram below. The voltage source forces voltage through the coil via sliding contacts or brushes that are connected to the DC source.

These brushes are found on the end of the coil wires and make a temporary electrical connection with the voltage source. In this motor, the brushes will make a connection every 180 degrees and current will then flow through the coil wires. At 0 degrees, the brushes are in contact with the voltage source and current is flowing. The current that flows through wire segment C-D interacts with the magnetic field that is present and the result is an upward force on the segment. The current that flows through segment A-B has the same interaction, but the force is in the downward direction. Both forces are of equal magnitude, but in opposing directions since the direction of current flow in the segments is reversed with respect to the magnetic field. At 180 degrees, the same phenomenon occurs, but segment A-B is forced up and C-D is forced down. At 90 and 270-degrees,

Brushed

The brushed DC motor generates torque directly from DC power supplied to the motor by using internal commutation, stationary permanent magnets, and rotating electrical magnets. Advantages of a brushed DC motor include low initial cost, high reliability, and simple control of motor speed. Disadvantages are high maintenance and low life-span for high intensity uses. Maintenance involves regularly replacing the brushes and springs which carry the electric current, as well as cleaning or replacing the commutator. These components are necessary for transferring electrical power from outside the motor to the spinning wire windings of the rotor inside the motor.

Synchronous

Synchronous DC motors, such as the brushless DC motor and the stepper motor, require external commutation to generate torque. They lock up if driven directly by DC power.

Brushless

Brushless DC motors use a rotating permanent magnet in the rotor, and stationary electrical magnets on the motor housing. A motor controller converts DC to AC. This design is simpler than that of brushed motors because it eliminates the complication of transferring power from outside the motor to the spinning rotor. Advantages of brushless motors include long life span, little or no maintenance, and high efficiency. Disadvantages include high initial cost, and more complicated motor speed controllers.